16117197076-3 BMW Fuel Pump
VDO OEM NEW Fuel Pump Assembly For BMW E90 335i 320i 130i 323i 16117197076
16117197076-3 BMW fuel pump with direct-fit replacement coverage for VDO OEM NEW Fuel Pump Assembly For BMW E90 335i 320i 130i 323i 16117197076. Fitment...
Source listing data is retained for verification; checkout stays on CarsAndTrucks.parts.
16117197076-3 Compatible Part Numbers
Cross-reference BMW and supplier numbers include 16117197076-3, 16117197076, A2C53101330Z, A2C53101330, 16147163297, A2C5. Always verify the current part number against the vehicle before ordering.
16117197076-3 Fitment
| Year Range | Application | Fitment Note | Transmission |
|---|---|---|---|
| 1970 | VDO OEM NEW Fuel Pump Assembly For BMW E90 335i 320i 130i 323i 16117197076 | Fitment Type: Direct Replacement | Compatible Makes: BMW | Model: 120i, 130i, 320i, 323i, 325i, 330i, 335i, X1 | Year: 2004-2014 | All |
16117197076-3 Description
16117197076-3 is a new VDO Dayton direct replacement listed for VDO OEM NEW Fuel Pump Assembly For BMW E90 335i 320i 130i 323i 16117197076. This page is intended to help match the BMW fuel system part by part number, vehicle application, and the visible product details shown in the listing. Because BMW fuel pumps, sending units, and high-pressure pump assemblies can vary by chassis, engine, production date, tank side, and connector layout, the part number should be treated as the most important fitment signal.
Before ordering, compare the number on the original component with the primary number on this page and review any cross-reference numbers shown below. Also verify the fuel type, pump location, electrical connector, line fittings, seal style, and whether the vehicle uses an in-tank module, sender assembly, inline pump, or engine-mounted high-pressure pump. The source data for this listing does not include every engineering specification, so the OE number and vehicle application should be treated as the primary fitment checks.
Fitment Type: Direct Replacement | Compatible Makes: BMW | Model: 120i, 130i, 320i, 323i, 325i, 330i, 335i, X1 | Year: 2004-2014 If the vehicle has had previous fuel-system work, confirm that the installed pump has not already been superseded to a newer BMW or supplier number. A small difference in connector indexing, fuel level sender arm, pressure rating, or tank orientation can prevent a similar-looking pump from fitting correctly. Cross-reference numbers captured for this listing include 16117197076, A2C53101330Z, A2C53101330, 16147163297, A2C5.
Common reasons to replace or inspect this type of BMW fuel pump part include long crank time, no-start conditions, low rail pressure, unstable fuel gauge readings, intermittent stalling, fuel starvation under load, or diagnostic trouble codes related to pump control or fuel pressure. Those symptoms can also be caused by relays, wiring, clogged filters, tank contamination, pressure regulators, or control modules, so basic diagnosis is recommended before replacing parts.
During installation, work safely around fuel, relieve system pressure where required, and inspect the tank opening, locking ring, gasket, strainer, fuel lines, and electrical terminals before reassembly. Use the product photos, part-number list, and fitment table on this page together with the vehicle VIN or original component label. If two BMW listings appear similar, choose the one that matches the OE number and physical layout rather than relying only on model name or year range.